www.bodor.com/service@bodor
.com
5) Do regular maintenance and inspections of machine in accordance with the requirements in 8
Maintenance.
6) Even if the main power switch is in the "OFF" position, the following parts and their conductors are still live!
Power supply line and main power switch incoming terminals are still live.
Servo drivers, frequency converter and switching power supply may still be live within 20 minutes after power off.
Do not touch their parts and the conductors connected to them.
7) Do not move the positions of safeguards. Otherwise, Bodor Laser will not be responsible for repair or any damage caused
thereby.
8) Take safety preventive measures in the manual to prevent personal injury or machine damage when doing maintenance
work.
9) Reinstall the safeguards and make sure them in correct position and effective working states after removing the
safeguards for maintenance purpose.
10) Use the parts and materials confirmed by Bodor Laser when replacing new parts.
11) Any technical modification of the machine must be done by Bodor Laser or with the confirmation of Bodor Laser.
2.10 Laser safety
Laser equipment is broken down into different laser classes according to the European standard EN 60825-1, laser class
indicates the hazard level of laser beam irradiated, as shown in Table 2-6.
Table 2-6 Laser classes
Laser beams available are not dangerous under predictable proper conditions.
To Next Page
Loading...
