www.bodor.com/service@bodor
.com
When unloading and transferring the equipment after its arrival, select auxiliary equipment according to the equipment
on-site installation instructions of the corresponding models of Bodor Laser i series, such as forklift, crane, travelling crane.
If the crane or travelling crane is used, it is only allowed to hoist the position of the lifting ring with the hoisting label.
During the use of the forklift, special attention should be paid to avoiding the vulnerable parts of the equipment, such as
sheet metal parts, to prevent the forklift from damaging the equipment. It is strictly prohibited to use a forklift for handling
the equipment with relatively long overall length, uneven center of gravity that is easy to be dumped.
If conditions permit, the preferred choice is to use a forklift and a travelling crane to unload and transfer the equipment and
its accessories to the designated location.
If there is no travelling crane line or its tonnage cannot meet the requirements in the plant, please select crane and forklift
for unloading. And use appropriate transferring equipment and loading methods to deliver the laser cutting machine and its
accessories to the designated location. Note: The unloading method of each equipment is slightly different, and the specific
requirements of the corresponding model shall be followed.
Under the conditions that the plant is small with no travelling crane.Ⅰ:Unload the equipment outside the plant before
transferring with cranes, forklifts or double forklifts; place transport tanks below the front of lathe bed of the equipment and
use forklifts at the rear side to move it to the specified location.
Under the conditions that the plant is small with no travelling crane. II : Unload the equipment outside the plant before
transferring with cranes, forklifts or double forklifts; place transport tanks below four corners in the front and rear of lathe
bed of the equipment; and move it to the specified location with crow bars.
Warning
The equipment should be hoisted and handled by a professional transport company. If the customer needs to handle
and hoist the equipment on his or her own, personnel in charge should receive professional training as well. If the
customer changes the hoisting mode, Bodor Laser will not be liable for damage to the equipment and personal
injury.
To Next Page
Loading...
