www.bodor.com/service@bodor
.com
II. Transport and Handling
2.1 Requirements for Transport
The laser cutting machine should be firmly fixed in transit to prevent damage. The packed product should be able to be
transported to any place on the secondary road. During long-distance transportation (including sea transport, rail transport,
road transport, etc.), the machine shall not be loaded in the open trunk or in the cabin, not allowed to be transported together
with the inflammables, explosives, corrosives and other dangerous goods. It is not allowed to get wet due to rain, snow and
liquid substances. Mechanical collision or damage is not allowed. Electrical equipment shall be designed to withstand --25 °
C ~55 ° C storage and transport temperature, up to 70 ° C The storage and transportation temperature of C should not
exceed 24 hours. It is required to provide the appropriate methods to prevent excessive moisture, rocking, squeezing and
mechanical collision of the goods during the process of transport.
2.2 Requirements for Handling
All hauling operations should be carried out in accordance with transport regulations.
The machine tool shall not be placed on the ground without floor tiles; otherwise, the bottom of each component will be
damaged! The base plate of the machine tool must be 100mm or more above from the ground, and such a distance must be
also maintained when the machine tool is transported to the installation site.
The ground conditions of the installation site must meet the requirements of installation conditions. The user must provide
the conditions for installation according to the layout drawing before the machine tool arrives.
When the equipment reaches the customer, the load capacity of lifting equipment required by unloading and transferring
depends on the type of the product purchased by the customer.
When the equipment reaches the customer, various tools for the unloading, unpacking and positioning of the equipment
should be selected strictly according to the equipment on-site installation instructions of the corresponding model of Bodor
Laser i series. The operations should be strictly carried out according to the equipment on-site installation instructions of the
corresponding model of Bodor Laser i series.
To Next Page
Loading...