www.bodor.com/service@bodor
.com
1.1 List of Main Maintenance
Removal of slags and dust on the X,Y-axis
dustproof cloth
Check and clean up dust and slag on the
X,Y-axis dustproof cloth.
Slags and dust collection containers-scrap
vehicle
Check and clean up slags and dust
collection containers - scrap vehicle.
Removal of slags and dust on the X-axis
protection plate
Clean up slags and dust on the X-axis
protection plate.
Clean the sheet metal appearance of the
device
Clean up dirt dirt grease
Inspection of the pneumatic components and
pipelines of the pneumatic system
Check the pneumatic components,
pipelines, etc of the pneumatic system
Inspection of the gas circuit components and
pipeline of the gas source
Check gas circuit components, pipeline, etc.
of the gas source
Inspection of the circulating water pipeline
Check the circulating water pipeline, etc.
Dust cleaning and guide rail lubrication of
parts in the head shell
Clean the dust of the parts in the head shell,
and oil the surface of the guide rail
Clean the sheet metal inside the device
Clean up dirt dirt grease
Refueling and cleaning of the
self-lubricating container
Check whether to timely refuel the
self-lubricating container, and check and
clean up oil circuit.
Inspection and cleaning of slag on the
countertop blade.
Clean the slag on the countertop blade.
Replace if necessary.
Middle square pipe and hopper slag and dust
cleaning
Check the air inlet and hopper slag and dust
and clean it
To Next Page
