www.bodor.com/service@bodor
.com
Guide of Complete Machine Assembly and
Disassembly
Important notes
The guide of complete machine assembly and disassembly includes preparation and all other information for placement and
use of the machine tool before use.
Tip
I series are the equipment with multiple models for cutting metal materials with laser, and it is not allowed to use the
i series to cut non-metal materials (e.g. glass, acrylic, wood, etc.).
Tips
All the conditions described in this Chapter must be met before the arrival of the machine tool. Otherwise, the Bodor
Laser’s After-sales Service Department will not provide any services before the machine tool is put into operation. Please
make all the preparations in advance according to the following work plans.
Tips
Before the equipment officially runs, the machine tool should be operated only by personnel authorized by Bodor Laser or
by Bodor Laser’s after-sales service personnel.
Tips
The initial debugging and running of the machine tool should be carried out only by Bodor Laser’s debugging service
personnel or customer service commissioners.
Include:
1) Place, calibrate, level correction and fix the machine tool.
2) Add the coolant.
3) Connect the machine tool to the supply system (except the power source).
To Next Page
Loading...
