www.bodor.com/service@bodor
.com
attached with tempered glass, which makes the shape more beautiful. The front door adopts
electronic control vertical lifting door structure, open and close with one key operation, and respectively equipped with
deceleration, stop detection switch, higher safety performance. The display screen adopts touch screen, high sensitivity, both
visual sense and good handling. Bolts are used to connect the outer enclosure with the main body of the equipment, so that
the whole shipment can be carried out without reassembling at the customer's site. The front cover is provided with a visual
window to facilitate the operator to observe the cutting process; Laser protective glass is pasted inside the window, which
can effectively prevent the harm of laser to the operator's vision when cutting.
1.3 Introduction to Each Functional System
1.3.1 Dedusting system
The laser cutting machine is configured with the dust collection system, and the dust collection pipeline in lathe bed body ,
air duct with a large diameter and high power fan are used to effectively inhale dust generated during laser cutting process,
and to collect emissions, ensuring the health of the operator.
1.3.2 Air circuit system
The air circuit part of the laser cutting machine is divided into two types, cutting air circuit and working air circuit. The
cutting air circuit is used to supply low-pressure oxygen and high-pressure nitrogen for cutting. The working air circuit is
used to supply compressed air for pneumatic unit. All gases should be dry and clean, with high purity and have no oil.
The main function of oxygen is to cut ordinary carbon steel, and that of nitrogen is to cut non-ferrous metals such as
stainless steel and alloy steel. The use of different cutting gases depends on different materials.
To Next Page
Loading...
