www.bodor.com/service@bodor
.com
Instructions of Equipment
Maintenance and Repair
Professional maintenance is the prerequisite for maintaining machine tools; it can effectively avoid running faults and the
consequences incurred.
Conducting the maintenance work when the machine tool is connected, there
may be life dangerous!
1) If no other clear instructions, turn off and lock the main switch, and pull out
the key.
2) Strictly abide by the safety regulations.
Before putting into operation
Before the machine tool is put into operation, the machine must be lubricated carefully according to the lubrication chart.
For export products by sea or other means of transport, it is necessary to clean up 204-1 replacing-type anti-rust oil before
the equipment is put into operation, and check the lubrication condition of the entire machine tool at the same time. When
necessary, completely remove all lubricating points and the concretionary lubricants in the pipeline.
Precautions for cleaning operation
Regularly clean the equipment.
Sweep away big dirt or clean it with an industrial vacuum cleaner.
Precautions for lubrication
The lubrication of the machine tool shall be carried out according to the lubrication chart and maintenance instructions. In
addition, attention should be paid to the following points:
1) The inlet and outlet should be kept clean, and opening time not exceed the time required.
2) Waste oil can be eliminated only in the state of equipment warm-up.
3) Only wiping rag without fiber flock and diluent lubricant for guide rail can be used to clean the lubrication part; it is not
allowed to use waste wool and benzene-contained liquid for cleaning.
4) Synthetic lubricants shall not be mixed with mineral oils or synthetic lubricants produced by other manufacturers (even
To Next Page
Loading...
