102 en | Control Center Digital Video Recorder
F01U | 1.0 | 2007.11 User Manual Bosch Security Systems
• HTTP port no.: Enter the HTTP port number.
• Bandwidth limit: Enter the bandwidth to adjust the data traffi c.
Mail settings
Set the mail options.
• Notifi cation: When you mark up the notifi cation option, notify the user about unit operating
information by e-mail according to your notifi cation settings.
• TLS: Mark up when using the TLS (Transport Layer Security) function.
• SMTP server: Enter the SMTP server address.
• SMTP port no.: Enter the SMTP port number. Typically the TCP port used for SMTP is 25.
However, in some cases it is better to change this port number for added fl exibility or security.
If desired, change the port number (1 ~ 65535).
• User name: Enter the user name.
• Password: Enter the password.
• Mail address (1~3): Enter the mail address. You can input up to 3 e-mail addresses.
Note:
The [SMTP server], [SMTP port no.], [User name] or [Password] settings
are optional. The DVR can send e-mail directly without the use of an SMTP
server or an MTA (message transfer agent). In certain cases all e-mail
should be forwarded to a specific SMTP server. Specify the server host
name or IP address in such cases. For more detail on SMTP setup, ask your
network administrator and/or mail service provider.
Notification
Set the notifi cation options.
• Alarm on: Sends an e-mail when an input has been activated.
• Video loss: Sends an e-mail when a video signal from the camera has stopped because of a
cable disconnection or malfunction of a camera.
• Motion detect: Sends an e-mail when motion detection has occurred.
• Power on/off: Sends an e-mail when power is on or off.
• Disk full: Sends an e-mail when the HDD has fully recorded.
• Admin PW changed: Sends an e-mail when the administrator password has changed.
DDNS
• User ID: Enter the DDNS registered user name.
• Password: Enter the user password in [User ID].
Note:
The DDNS function is serviced using a TCP 8245 port by “No-IP” (http://
www.no-ip.com/).
In case the DVR is used in the network system with a firewall, open the
TCP 8245 port so that DDNS data can get into firewall. For more detail
on firewall setup, ask your network administrator and/or network service
provider.
To Next Page
Loading...
