104 en | Configure the system PRAESENSA
2020-09 | V1.20 | PRAESENSA 1.20 Configuration manual Bosch Security Systems B.V.
5.10.2 Restore
If the configuration file on your system controller becomes e.g. corrupt or configuration items
are lost or changed by accident, and/or when your system controller is replaced, it can be
restored only when you have made a backup. See
Backup, page 103
.
– IMPORTANT: Notice that recorded messages are not part of the backup
configuration .tar.gz file:
– Be sure that the used recorded messages are stored on a safe place and that they
possible need to be uploaded again after restoring the configuration file. This step is
only needed in case the system controller is/was reset to default and/or replaced.
See also
Recorded messages, page 68
.
Restore your configuration file
Proceed as follows:
1. Below the Backup and restore configuration page, click Restore:
– A screen appears with the following items:
2. Click the Browse button:
– Depending on the web browser type (e.g. Firefox, Edge, etc.) A (different) file
selection screen appears.
3. Browse to, and select, the .tar.gz file which need to be restored.
4. Enter your Password (used for the backup) in the text box below Provide password when
backup contains user credential and certificates:
5. Click the Restore button:
– The selected configuration and credentials file will restore your system configuration.
6. Upload the messages, if required. See
Recorded messages, page 68
.
– IMPORTANT: After restore, the used recorded messages need to be uploaded to the
system controller, again. This step is needed in case the system controller is reset to
default and/or replaced.
7. Upload/Activate the certificate(s), if required. See
Open interface, page 114
.
– IMPORTANT: This step is needed in case the system controller is reset to default
and/or replaced.
Refer to
– Recorded messages, page 68
– Backup, page 103
To Next Page
Loading...
