Bosch PRAESENSA PRA-CSLD - Operation; Menu Bar

126 en | Optional: Using the Logging Viewer PRAESENSA
2020-09 | V1.20 | PRAESENSA 1.20 Configuration manual Bosch Security Systems B.V.
12.3 Operation
The Logging Viewer contains the following:
– Menu bar - A menu bar that provides access to the menus of the Logging Viewer.
– Show active button - A button to select between showing all fault events,
irrespective of status, or just the active fault events, that have not been reset. This
button is only available in the Fault Events tab.
– Block buttons - Two buttons to select the next and previous blocks of events.
– Logging Status button - A button that opens a window that shows the status of the
Logging Viewer. When the Logging Server or Logging Viewer does not operate
correctly, the button is red.
– Tabs - Use the tabs to select the type of events that are shown by the Logging
Viewer. For information about events, see Event messages, page 134 .
12.3.1 Menu bar
The menu bar contains the following:
– The File menu.
– The View menu.
– The Systems menu.
– The Action menu.
– The Help menu.
File
The items in the File menu are used to export and print events and to configure the Logging
Viewer. It contains the following items:
– Options :Opens the Options window that is used to configure the Logging Viewer.
– Export: Exports all events in the current event view to a comma separated values file
(*.csv). This file can be opened with, for example, Microsoft® Excel.
– Print: Prints all events in the current event view or prints a selected block of successive
events. (To select a block of events: click the first event and then hold the <Shift> key and
click the last event.)
– Exit: Closes the Logging Viewer.
View
The items in the View menu are used to set the event viewing options. It contains the
following items:
– Recent :Shows all recent events. The number of displayed recent events is defined by the
Logging Server window.
– Historical: Shows historical events. These are retrieved from the logging database. When
this item is selected, a calendar appears in which a start date (Start Date) and an end
date (End Date) can be selected. When the number of historical events is more than
10000, the Logging Server delivers the events in blocks to the Logging Viewer. Use the
NextBlock and Prev. Block buttons to scroll through the blocks.
– Refresh: Refreshes the list of events.
Notice!
New events are only shown in the Recent view. The Historical view does not show new
events.