PRAESENSA Tones | en 153
Bosch Security Systems B.V. Configuration manual 2020-09 | V1.20 | PRAESENSA 1.20
19 Tones
Each tone and/or pre‑recorded (spoken) message used in the PRAESENSA system must have
the .wav audio file format. See
Recorded messages, page 68
.
The following .wav files (tones) are PRAESENSA predefined, are mono and have a 16-bit
sample depth and 48kHz sample rate. Be noticed that tones could be updated and new tones
could be added. Previous means that possible tones are not all/different listed in this
document version. See
(Mandatory) software, page 16
> Tones, for the latest version available.
–
Attention tones, page 153
–
Alarm tones, page 156
–
Test tones, page 159
See also
Call definitions, page 81
.
19.1 Attention tones
Attention tones are mainly used for a start and/or end tone at an announcement.
Filename format: Attention_<sequence number>_<number of tones>_<duration>.wav
– Attention_A_1T_1.5s.wav
– Single tone chime
– Marimba and Vibraphone, A4
– Peak level -6 dBFS, RMS level < -10 dBFS, 1.5 s
– Attention_B_1T_1.5s.wav
– Single tone chime
– Marimba and Vibraphone, C#5
– Peak level -6 dBFS, RMS level < -10 dBFS, 1.5 s
– Attention_C_1T_1.5s.wav
– Single tone chime
– Marimba and Vibraphone, E5
– Peak level -6 dBFS, RMS level < -10 dBFS, 1.5 s
– Attention_D_1T_1.5s.wav
– Single tone chime
– Marimba and Vibraphone, G5
– Peak level -6 dBFS, RMS level < -10 dBFS, 1.5 s
– Attention_E1_2T_2s.wav
– Two tone pre-chime
– Marimba and Vibraphone, A4/C#5
– Peak level -6 dBFS, RMS level < -10 dBFS, 2 s
– Attention_E2_2T_2s.wav
– Two tone post-chime
– Marimba and Vibraphone, C#5/A4
– Peak level -6 dBFS, RMS level < -10 dBFS, 2 s
– Attention_F1_3T_2s.wav
– Three tone pre-chime
– Marimba and Vibraphone, G4/C5/E5
– Peak level -6 dBFS, RMS level < -10 dBFS, 2 s
– Attention_F2_3T_2s.wav
– Three tone post-chime
– Marimba and Vibraphone, E5/C5/G4
– Peak level -6 dBFS, RMS level < -10 dBFS, 2 s
– Attention_G1_3T_2.5s.wav
To Next Page
Loading...
