6 en | General information PRAESENSA
2020-09 | V1.20 | PRAESENSA 1.20 Configuration manual Bosch Security Systems B.V.
1 General information
The purpose of this configuration manual is to provide all required information needed for the
configuration/programming of the Bosch PRAESENSA products. It will guide new users
step‑by‑step and serves as a reference for experienced users.
– Unless required for the configuration of the products, this manual does not describe
hardware installation instructions. Refer to
Related documentation, page 7
.
– This manual, or an update, in pdf format is available as download from
www.boschsecurity.com > PRAESENSA product section. Refer to
Related documentation,
page 7
.
Manual content
Refer to the following sections before and during configuration of your system:
– Chapter 1:
General information, page 6
- gives information on the intended audience,
training, available documentation, explains how to use this manual and provides a
high‑level introduction description of the PRAESENSA Public Address and Voice Alarm
System.
– Chapter 2:
Product overview, page 13
- gives an PRAESENSA product overview.
– Chapter 3:
Getting started, page 14
- describes software installation instructions and
important procedures which have to take into account before, and during, configuration.
– Chapter 4:
Logon the application, page 35
- describes how to logon the PRAESENSA
webserver webpages and important procedures which have to take into account before,
and during, configuration logon.
– Chapter 5:
Configure the system, page 37
- describes everything what you have to know
about the configuration of a PRAESENSA system.
– Chapter 6:
Diagnose, page 105
- describes i.e. configuration, amplifier loads and battery
impedance diagnostics.
– Chapter 7:
Security, page 112
- describes how to change security credentials, reconnect
lost and disconnected devices and Open Interface client certificate connections.
– Chapter 8:
Print configuration, page 115
- describes how to print device and/or system
configuration settings.
– Chapter 9:
About, page 117
- describes how to view certificates and (Open Source
Software) licenses.
– Chapter 10:
Introduction to make an announcement, page 118
- describes what, and how,
to setup announcement content, priority and routing.
– Chapter 11‑16: Describes how to use different (3
th
party) applications with PRAESENSA.
– Chapter 17:
Troubleshooting, page 133
- describes PRAESENSA troubleshoot options.
– Chapter 18:
Event messages, page 134
- provides information about (general and fault)
events which could generated by the PRAESENSA system.
– Chapter 19:
Tones, page 153
- provides information of tones (messages) to be used with
PRAESENSA.
– Chapter 20:
Support and academy, page 161
- provides (technical) support and training
information.
Refer to
– Support and academy, page 161
1.1 Intended audience
This configuration manual is intended for everyone who is authorized to do the configuration
of PRAESENSA and related products.
To Next Page
Loading...
