PRAESENSA Configure the system | en 79
Bosch Security Systems B.V. Configuration manual 2020-09 | V1.20 | PRAESENSA 1.20
5.5.3 BGM routing
At the BGM routing page, background music (BGM) routing can be defined. A BGM routing
refers to an audio input in the system. Optionally, default zones and or default zone groups
can be connected to the routing. When the system is switched on, then the specified BGM is
routed to the connected zones and zone groups.
BGM routing configuration page
1. Below the Zone definitions page, click BGM routing:
– A screen appears listed the following items:
2. Select, enable or disable each of the following items:
Item Value Description
Name Selection Shows the name of the BGM routing
(dropdown list selection). See Add BGM
routing topic in this section.
Type Selection Selection between zones and zone groups as
available routing.
Zones / Zone groups Selection The left box area shows the available zones
and zone groups. Zones (groups) are created
in
Zone options, page 75
and
Zone grouping,
page 77
> and < Buttons Using the > and < buttons, selected zones
and zone groups can be added to, or removed
from, Routing (the right area box).
Audio input Selection Select the Audio input that provides the
background music. Notice that the inputs 9
up to 16 are secured (Dante/OMNEO
channels) to the amplifier. The same Audio
input may not be assigned to different BGM
routing. Each BGM routing must have a
unique audio input.
Limit routing Enable / Disable Enable: The center box area shows the zones
and zone groups that are allowed to receive
the BGM routing. This center box area is not
visible if the Limit routing checkbox is
disabled. Using the > and < buttons, selected
zones and zone groups (left area box) can be
added to, or removed from Limit Routing (the
middle area box). See also the Limit routing
topic in this chapter.
Routing Selection The right box area shows the zones and zone
groups that are assigned to the selected BGM
routing at system start‑up. Using the > and <
buttons, selected zones and zone groups (the
left or middle area box) can be added to, or
removed from Routing (right area box).
To Next Page
Loading...
