PRAESENSA Configure the system | en 37
Bosch Security Systems B.V. Configuration manual 2020-09 | V1.20 | PRAESENSA 1.20
5 Configure the system
Using the Configure section, the PRAESENSA devices / system functionality can be defined.
IMPORTANT: Only PRAESENSA administrator and installer user accounts have access to the
Configure section. See
User accounts, page 38
.
– The order of the configure menu items in this section, which is opened when the
Configure button is clicked, represents the recommended workflow for the configuration
of a PRAESENSA system.
– See also:
Configuration do's and don'ts, page 33
Configure (menu items)
1
User accounts, page 38
The user accounts that provide access to the
PRAESENSA webserver can be managed.
2
System composition, page 40
The network devices of which the system must
consists can be added or removed.
3
Device options, page 43
Each network device that has been added using the
System composition pages can be defined.
4
System options, page 68
A number of general system settings can be defined.
5
Zone definitions, page 75
The routing of zones, zone group, BGM, audio inputs
and audio outputs of the amplifiers can be defined.
6
Call definitions, page 81
The announcement options (call definitions) can be
defined.
7
Action definitions, page 84
The buttons of the call station (extension) and the
control inputs can be defined.
8
Audio processing, page 97
The audio processing parameters (equalizer + volume)
of the call station audio inputs and the amplifier audio
outputs that can be set.
9
Save configuration, page 102
The current configuration can be saved.
10
Backup and restore, page 103
A saved configuration can be backup and/or restored.
Notice!
The logon and configuration time‑out is about 10 minutes. Submit your changes before the
time‑out exceeds, otherwise your changes are lost.
To Next Page
Loading...
