PRAESENSA Configure the system | en 67
Bosch Security Systems B.V. Configuration manual 2020-09 | V1.20 | PRAESENSA 1.20
5.3.5 System client
1. Below Device options, Click System client:
– A new screen appears with a General category tab.
– Notice that a System client is only listed when it is added to the
System
composition, page 40
.
2. Select and click the + of the General category tab to configure the general settings of the
System client:
3. Enable (checkmark) the supervision checkbox:
– The connection with the IP‑address will be supervised. A fault for the missing system
client will be reported after a grace timeout of 10 minutes.
4. Click the Submit button to store the settings:
– Notice that the changes are not permanent until the configuration is saved. See
Save
configuration, page 102
.
To Next Page
Loading...
