PRAESENSA Configure the system | en 61
Bosch Security Systems B.V. Configuration manual 2020-09 | V1.20 | PRAESENSA 1.20
Item
(LCD menu)
Value Description
individual set of available messages. See also
the Recorded messages section further in this
chapter.
Alert messages * Enable / Disable Enable: The Alert messages are separated
from Recorded messages to avoid the
accidental start of an evacuation. When Alert
messages is enabled an Alert tile will be
available on the start screen of the call
station display. The operator will touch the
Alert tile to start with the procedure to send
Alert messages. The intended operator of this
function is for example the receptionist and
not the fire fighter. In case of an emergency
the operator is not authorized and cannot
decide which alert messages goes to which
areas. Therefore a fixed assignment of the
Alert message to the areas/zones must be
preconfigured. See also the Alert messages
section further in this chapter.
Fault log * Enable / Disable Enable: When Fault log is enabled a Fault Log
tile will be available on the start screen of the
call station display. The Fault Log tile is for
the call station operator who will touch the
Fault Log tile to see an overview of logged
device and system faults.
Local volume * Enable / Disable Enable: When Local volume is enabled, a
Volume tile will be available behind the
Settings tile on the start screen of the call
station display. The operator will touch the
Settings tile first to access the Volume tile
and will touch the Volume tile to start with
the procedure to adjust and set the audio
output level of the call station monitor
loudspeaker.
Information Enable / Disable Enable: When Information is enabled an
Information tile will be available behind the
Settings tile on the start screen of the call
station display. The operator will touch the
Settings tile first to access the Information
tile. This function is to visualize e.g. the
hardware and software versions of the call
station and connected call station
extension(s). Use this information when
contacting technical support (e.g. Service).
To Next Page
Loading...
