2-2 Important Directions for Use Rexroth IndraDrive
DOK-INDRV*-HMV-*******-PR01-EN-P
Areas of Use and Application
Supply units of Rexroth are designed to supply the Rexroth IndraDrive M
drive controllers.
Control and monitoring of the motors may require additional sensors and
actors.
Note: The supply units may only be used with the accessories and
parts specified in this document. If a component has not been
specifically named, then it may not be either mounted or
connected. The same applies to cables and lines.
Operation is only permitted in the specified configurations and
combinations of components using the software and firmware
as specified in the relevant function descriptions.
The supply units may only be operated under the assembly, installation
and ambient conditions as described here (temperature, system of
protection, humidity, EMC requirements, etc.) and in the position
specified.
2.2 Inappropriate Use
Using the supply units outside of the above-referenced areas of
application or under operating conditions other than described in the
document and the technical data specified is defined as “inappropriate
use".
Supply units may not be used if
• they are subject to operating conditions that do not meet the above
specified ambient conditions. This includes, for example, operation
under water, in the case of extreme temperature fluctuations or
extremely high maximum temperatures or if
• Rexroth has not specifically released them for that intended purpose.
Please note the specifications outlined in the general safety
instructions!
To Next Page
Loading...
