4-2 Identifying and Checking the Delivered Components Rexroth IndraDrive
DOK-INDRV*-HMV-*******-PR01-EN-P
4.3 Component Designation
Each drive component is identified by a type designation.
A type plate is attached to all units, including the motor.
A label (cable marker) is wrapped round the ready-made cable. The type
designation and length are indicated on this label. (The designation for the
cable itself, without connector, is printed on the cable sheath.)
The identification of accessories packed in bags is either printed on the
bag or indicated in an accompanying note.
Type Plates on the Unit
hmv_typenschild.fh7
Fig. 4-2: Type plate arrangement
To Next Page
Loading...
