Bosch Rexroth IndraDrive HMV01.1R-W0045 - Connecting Cables and Rails; Connections (Power Section)

Rexroth IndraDrive Electrical Installation 7-11
DOK-INDRV*-HMV-*******-PR01-EN-P
7.5 Connecting Cables and Rails
Connections (Power Section)
Overview
installation_hmv_system.fh7
23
A
B
C D
4
5
6
1
No. Designation
A UPS (uninterruptible power system)
B 24 V control voltage supply
C Supply unit
D Drive controller
1 PE connection of mains supply
2 Mains connection
3 PE connection to drive controller;
If cables are used for ground connection they must have a cross section of at least 10 mm
2
.
4 Module bus X1
5 Control voltage connection (+24V, 0V);
If connection with contact isn’t possible you can also use wires.
6 DC bus connection (L+, L-);
If connection with contact isn’t possible you can also use wires.
Fig. 7-7: Connections - overview