7-32 Electrical Installation Rexroth IndraDrive
DOK-INDRV*-HMV-*******-PR01-EN-P
• At the first and last drive controller in a line of devices connected to
each other there mustn’t any cutout be broken off at the outer side of
the touch guard.
Mounting
The touch guard must always be mounted following connection work.
hmv_beruehrschutz
Fig. 7-41: Touch guard
Note: Risk of damage to the touch guard!
The maximum tightening torque for the fixing screw for the
touch guard is 2.8 Nm.
2.8 Nm
Tightening Torque
To Next Page
Loading...
