Bosch REXROTH mMS 4.0 - 5.2.2 Processing with press station

22/68 Bosch Rexroth AG Training system mMS 4.0 | R901429162/04.16
About this product
5.2.2 Processing with press station
The processing with pneumatic/hydraulic press station comprises a table with
lockable guide rollers and the following function modules assembled on top of it:
 Pinning unit
 Portal with vacuum suction gripper
 Pneumatic or hydraulic press
 Machine control panel
 Conveyor belt
 Maintenance unit
 Light barriers
 Electrical supply with signal processing
– Main switch on left-hand side of the system
– Connector to right-hand/left-hand station
– Mains supply, fuses
– 3 emergency stop relays
– Field bus, Profibus
 Programmable logic controller XLC L25 with supplied PLC software
The work piece is moved from the previous conveyor belt to the conveyor for this
station. It passes a light barrier and 2 pins are applied to it in the pinning unit.
Afterwards, it is moved further along by the conveyor belt until the work piece
is transferred into the press with the portal vacuum suction gripper. The second
work piece comes from the previous station and is transported to the press in the
same way. A pneumatic cylinder in the press presses the work pieces together.
The portal's vacuum sucker transfers the work piece to a conveyor for transport
onward.
Fig. 9: Processing station
1 Pinning unit
2 Conveyor belt
3 Sensors
4 Portal
5 Press
6 Maintenance unit
6
2
3
4
1
5