Bosch REXROTH mMS 4.0 - 13.2 Maintenance schedule; 13.2.1 Working materials, consumables, tools, measuring devices

64/68 Bosch Rexroth AG Training system mMS 4.0 | R901429162/04.16
Maintenance work
13.2 Maintenance schedule
In the following table, the work is shown by maintenance interval and then by
assembly/part. The intervals contain.
Table 12: Training system maintenance schedule mMS 4.0
 When the mMS 4.0 training system is out of service, the following applies:
 Tighten loose connections such as screws, nuts, splints, clamps right away.
13.2.1 Working materials, consumables, tools, measuring devices
To work on the mMS 4.0 training system, the following is required:
 Grease:
Standard lithium grease
 Occupational safety clothing as required
 Lubricants as per instructions
 Cleaning and conservation compounds:
Cleaning rags
Container for disposal of lubricants/waste
Inspection and maintenance report, writing materials
 1 set open-end wrench
 1 set hexagon socket wrench
 1 set screwdriver
When?
What?
Where?
Comments
Daily / prior
to each use
EMERGENCY STOP button
Check function.
Effect of sampling
Does not start up when locked
In the event of malfunction:
Place the installation out of service
Notify a qualified electrician
When?
What?
Where?
Comments
Weekly
Electronics
Check all functions:
Fuses, FI-switches
sockets
buttons
Have any defect parts replaced
Qualified electricians are only
to do the replacement
Monthly
or
as needed
24V mains supply DC where
present
Check all functions:
Connection cable,
main switch,
24V power supply unit, voltage
OK?
Have any defect parts replaced
Qualified electricians are only
to do the replacement
Cleaning
Overall training system
Remove dirt or existing lubricant residues.
As per
company
regulations
The entire electric installation
Inspection of protective
earthing conductor up-to-date?
Label present?
Inspection by qualified electrician only
Working materials
Aids
Tools