48/68 Bosch Rexroth AG Training system mMS 4.0 | R901429162/04.16
Set-up, installation and commissioning
9.4 Installing installation and stations
Pneumatic supply
The air feed should be connected to the station at the extreme left.
Connect the Ø6mm air supply hose to the maintenance unit.
Fig. 21: Compressed air feed connection
Danger caused by lashing hoses.
Risk of injurycaused by compressed air!
Before switching on the system, make sure all compressed air hoses have
been depressurized.
Do not connect pneumatic hoses under pressure.
Dangerous electrical voltage.
Death or serious injury!
Extracting current from the mains supply is prohibited!
Do not make any modifications to conductive parts!
To Next Page
Loading...
