Training system mMS 4.0 | R901429162/04.16 Bosch Rexroth AG 27/68
About this product
Zero point reference position
The zero point of the two axes of station 3 is stored by the batteries oft he
encoder cables oft he drives even in switched off mode. In case that a battery is
empty and replaced, the zero reference position is to be settled again. Both axes
must be moved to the position of the zero point. Doin this in the program in
explained in the documentation of the IndraDrive Cs. The axes must be move
mechanically to the right position. The right position is:
Horizontal axis:
Outer left edge to edge of carriage: 120mm
Vertical axis:
Lower edge of extrusion body to upper edge of flange: 189mm
Fig. 1: Reference zero point station 3
To Next Page
Loading...
