Bosch REXROTH mMS 4.0 - Filling the Racks

Training system mMS 4.0 | R901429162/04.16 Bosch Rexroth AG 29/68
About this product
Filling the racks
To load the separating racks with workpieces proceed as follows:
 Load aluminum cube half 50 x 50 x 25 mm into the right-hand rack from
above, while open.
 Load the workpiece using two fingers and guide it as you move it down.
 Load black plastic cube half 50 x 50 x 25 mm into the left-hand rack
downward, while open.
Fig. 4: Sliding in workpieces