Training system mMS 4.0 | R901429162/04.16 Bosch Rexroth AG 63/68
Maintenance work
13 Maintenance work
13.1 General information
Inadequate maintenance leads to
Faults,
Possible breakdown
High repair costs.
Observe the following instructions if anomalies, faults and wear is identified during
operation or during the inspection:
Immediately place the training system out of service.
Find the causes of the fault and fix the defects.
Replace the damaged part.
Do not put the mMS 4.0 training system back into operation where unsafe
to do so.
To Next Page
Loading...
