38/68 Bosch Rexroth AG Training system mMS 4.0 | R901429162/04.16
Operating and display elements
7 Operating and display elements
7.1 EMERGENCY STOP button
An EMERGENCY STOP button must be placed on the front of the training system.
All operating modules (machine control panels) have an EMERGENCY STOP
button which can close the EMERGENCY STOP circuit.
In the event of a risk to person or machine, switch off the mMS 4.0 training
system with the button.
Actuating the EMERGENCY STOP button interrupts the power supply.
All work procedures are stopped right away and any hazardous control currents
(servo drive) and thus all movements are switched off.
There is a local EMERGENCY STOP circuit for the individual station and a global
EMERGENCY STOP circuit for the entire installation.
The circuit diagram can be viewed in the enclosed CD.
Do not use the EMERGENCY STOP button to switch off the training system
normally!
To Next Page
Loading...
