Training system mMS 4.0 | R901429162/04.16 Bosch Rexroth AG 43/68
Transport and storage
8.2.2 Transporting between two buildings
Note the following during transport:
Ensure that the doors and passages are of sufficient size.
Remove attachment parts and device sets that are not needed beforehand.
Disconnect the 3 stations from all connections.
Carefully shift the individual stations.
Proceed as follows:
Disconnect the mains plug and stow away the power cable.
Remove the compressed air supplies.
Disconnect all connecting cables between the stations.
Transport the mMS 4.0 training system as follows:
Place each station of the mMS 4.0 training system onto a pallet.
Prevent the stations of the mMS 4.0 training system from falling using belts
or plastic ties; You can use the original transport crates.
Protect each station of the mMS 4.0 training system against moisture.
Transport the pallet with the mMS 4.0 training system with a fork lift truck
or similar.
Move the mMS 4.0 training system on a fixed and level base.
At the predesignated position carefully lift each station of the mMS 4.0 training
system out of the transport box or down from the pallet.
Remove any packaging and securing ties with belts and plastic ties.
Connect the voltage supply and compressed air supply.
Risk that the training system may fall over.
Risk of injury when lifting and transporting the machine!
When lifting and transporting the machine, always carefully do so with at least
two persons in order to prevent it from dropping.
Lift the mMS 4.0 training system by hand or with a floor conveyor.
To Next Page
Loading...
