Training system mMS 4.0 | R901429162/04.16 Bosch Rexroth AG 65/68
Disposal
13.2.2 Replace parts
Only use original spare parts.
When ordering spare parts, always specify the device type, material number,
year of manufacture and parts designation.
Get in touch with Bosch Rexroth After-sales.
For the address and other contact data, consult the reverse of this
operating manual.
www.boschrexroth.com/training
Immediately rectify the wear on the mMS 4.0 training system when
– Workplace safety and functions are not in place
– Subsequent damage is expected
If elements are damaged, check whether the wear limit has been reached.
Decide whether you need to replace the part or wait until the next
maintenance.
Only rectify wear when
– The mMS 4.0 training system is in an upright position safe for personnel and
– There is no risk to health (falling, slipping due to moisture, etc).
Have a skilled person check the following after rectification of the wear and
before the machine is put into operation
– Has the work been carried out properly
– Is the mMS 4.0 training system ready for operation without impairment.
14 Disposal
The training system is made of materials which are recyclable and can be reused.
Specialized firms cab recycle this training system to gain valuable materials from
it and to minimize the amount of material requiring disposal.
Dispose of the training system based on local and legal requirements.
Water-polluting materials such as hydraulic oil and cleaning liquids containing
solvents must not be allowed to contaminate the soil or get into the water supply.
Working materials and consumables must be placed in suitable containers,
stored, transported, collected and disposed of according to the legal
requirements. In case of doubt, obtain information about storage and disposal
types from the manufacturer / vendor.
To Next Page
Loading...
