60/68 Bosch Rexroth AG Training system mMS 4.0 | R901429162/04.16
Fault assistance
11.2 Troubleshooting
Basic procedure
Remove all workpieces from the stations.
Check
- All electrical connections for possible faults,
- The pneumatic and mechanical components for possible faults.
After the fault has been removed:
1. Actuate the reset button.
The reset button is lit.
If the reset pushbutton continues to flash, this means there is a fault.
2. Remedy the fault, then go to Step 1.
3. Press the Start button.
Process can be continued.
Restarting after a power failure
Remove all cubes and cube halves from the stations.
Empty the high-stack storage.
Re-establish the voltage.
The programmable logic controllers are rebooted.
Once they are ready, the reset and start buttons will flash.
To Next Page
Loading...
