50/68 Bosch Rexroth AG Training system mMS 4.0 | R901429162/04.16
Set-up, installation and commissioning
Electrical power supply
Operating an individual station
The following aspects must be satisfied to operate a single station:
The connector to the transfer connectors for signals and emergency stop
circuit must be pluggable on both sides.
If not, plug the terminating plug/-socket onto the transfer module and screw
in firmly.
The emergency stop circuit of the station is not closed until the terminating
plug/socket is plugged into the transfer connector.
Fig. 23: Terminating connector plugged in
The power supply connector is next to the main switch.
It must be connected to the electricity cable with an earthing-pin plug.
Afterwards, the station can be connected to 110 – 230 V AC.
Fig. 24: Connecting the power supply
To Next Page
Loading...
