Type Description Chapter
NCM02 NC module with SERCOS interface chapter 8 "NC Multifunction Card NCM02" on page
89
NCIO I/O module for fast I/Os chapter 9 "PLC Modules MTS-P01.2 and MTS-P02.2"
on page 107
MTS-P Integrated PLC chapter 10 "Tips and Tricks" on page 129
The openness of the control system allows the machine manufacturer to inde‐
pendently carry out application-specific hardware settings in the PC part, such
as measured values acquisitions , network connections etc. In this case, the
machine manufacturer must provide supplements to the hardware documen‐
tation.
1.3 Further Documentation
Fig.1-2: System architecture
The MTA 200 control system includes additional hardware components that are
described in separate documents :
Type Description Documentation
BTA 20.4 Machine operator control
panel
DOK-SUPPL*-BTA20.4****-PR0x-EN-P
BTM 15 Machine operator panel DOK-MTC200-BTM15******-PR0x-EN-P
BTM 16 Machine operator panel DOK-MTC200-BTM16.1****-FKBx-EN-P
PCK03 Drawer keyboard DOK-SUPPL*-PCK03.3****-PR0x-EN-P
BTC 06 Hand-held terminal DOK-SUPPL*-BTC06******-PR0x-EN-P
BTV 06 Mini control panel DOK-SUPPL*-BTV06.1****-PR0x-EN-P
8/135 Bosch Rexroth AG | Electric Drives
and Controls
Rexroth MTA 200 | Project Planning Manual
Overview
To Next Page
Loading...
