Fig.4-11: Position of the openings for slide-in strips
How to Replace Slide-in Strips
1. The delivered or self-made strips are to be cut out along the lines .
2. Chamfer the corners at the right end of each strips in order to simplify the
insertion.
3. Insert the strip carefully.
● To do this, hold the strip at an acute angle to the front plate and thread
it into the housing opening (see fig. 4-12 "Replacing slide-in strips"
on page 33, part A).
Note: The slide-in strip is to be inserted into the pocket of the glued
front-film (see fig. 4-12 "Replacing slide-in strips" on page 33). If
32/135 Bosch Rexroth AG | Electric Drives
and Controls
Rexroth MTA 200 | Project Planning Manual
Machine Operator Terminal BTV 20.4A
To Next Page
Loading...
