Bosch Rexroth MTA 200 - Replacing the Slide-In Strips; General Information

PLC function key Address key Address LEDs
S6 %I*.0.5 %Q*.0.5
S7 %I*.0.6 %Q*.0.6
S8 %I*.0.7 %Q*.0.7
S9 %I*.1.0 %Q*.1.0
S10 %I*.1.1 %Q*.1.1
S11 %I*.1.2 %Q*.1.2
S12 %I*.1.3 %Q*.1.3
S13 %I*.1.4 %Q*.1.4
S14 %I*.1.5 %Q*.1.5
Key switch left side (op‐
erator)
%I*.1.6 %Q*.1.6
Key switch right side
(Prog)
%I*.1.7 %Q*.1.7
Fig.4-10: Addressing of the PLC function keys
Two vacant logical addresses are to be assigned for inputs and outputs within
the PLC configuration.
4.2.6 Replacing the Slide-in Strips
General Information
The 14 PLC function keys on the front of the BTV 20 can be labeled by using
a slide-in strip . The key row above the PLC function keys (OP2...OP9) is also
freely configurable using slide-in strips.
These strips, which are already inserted when the device is delivered, can be
freely replaced. Preprinted strips as well as a floppy-disk with templates are
also included in the scope of delivery so that you can create your own key
labels. How to replace the slide-in strips is decribed below.
Project Planning Manual | Rexroth MTA 200 Electric Drives
and Controls
| Bosch Rexroth AG 31/135
Machine Operator Terminal BTV 20.4A