Fig.4-15: "BTV 20" control panel icon
2. If the "BTV 20" is not available in the control panel, the corresponding
program is to be installed. The program is on the utility floppy disk SWD-
BTV20*-UTI-01VRS that is delivered with the BTV 20. Installation: Insert
floppy-disk in drive A: and enter the A:\SETUP command via Start - Run.
After finishing the installation, shut down the operating system and start
again with point 1.
3. Select the desired keyboard layout in the following window and confirm it
by clicking "OK".
Fig.4-16: Menu for the layout of the internal keyboard
The language that is set here must agree with the settings of the
external keyboard in the operating system.
36/135 Bosch Rexroth AG | Electric Drives
and Controls
Rexroth MTA 200 | Project Planning Manual
Machine Operator Terminal BTV 20.4A
To Next Page
Loading...
