How do I eliminate resonance in my Bosch Rexroth REFUspeed RS51 system?
To correct a 'Resonance' issue with your Bosch Controller, try adjusting the operating point in the V/Hz characteristic. Alternatively, disable the output filter by setting P1224.xx = 0 for the appropriate parameter set (P1224.XX). Current resonance (oscillations) occur at an operating point between the motor and output filter of the drive converter.
What to do if the Bosch Controller shows a 'Switched-mode power supply' error?
Replace the defective switched-mode power supply. Depending on the drive converter version, the switched-mode power section is on the PC board: LT (power section), WS (inverter control) or SV (power supply).
What does 'Clock1 Clock2' mean on my Bosch Controller, and how can I fix it?
One of the two clock generators is defective, replace the module.
What should I do if my Bosch Controller displays a 'New EEPROM' error?
Please contact your customer service.
Details protection against electrical shock and contact with live parts.
Presents 10 rules for ensuring electromagnetic compatibility during installation.
Introduces the process of parameterizing the drive system.
Guides through the quick setup process for initial drive configuration.
Lists essential steps and checks before commissioning the drive system.
Details the procedure for the initial start-up and commissioning of the drive.
Differentiates between alarms and faults and their general behavior.
Details how to acknowledge faults and reset the drive.
Provides a comprehensive list of alarms and faults with their codes.
Offers detailed causes and recommended remedies for specific alarms and faults.
General| Category | Controller |
|---|---|
| Series | REFUspeed |
| Model | RS51 |
| Protection class | IP20 |
| Communication interface | CANopen |
To Next Page