AirborneM2M™ User Guide
16
CONNECTOR DEFINITION
There are a total of five connectors used by the AirborneM2M™ family. Which connectors are available on
your product depend on the model you purchased. The definition for the connectors is common to all
product classes. Table 4 provides definitions for the connectors.
Table 4 - Connector Description
Type Description Product Class
Serial DE-9 Connector Male Enterprise, Industrial
Ethernet RJ45 Plug Enterprise
Ethernet RJ45 Socket Industrial
Antenna RP-SMA Enterprise, Industrial
Power 2.1mm Barrel Jack Enterprise, Industrial
Power 2 Position Terminal Block Industrial
OEM RESET SWITCH (FACTORY RESET)
All AirborneM2M™ devices support the ability to reset the configuration back to OEM defaults. This is useful
when a device has been incorrectly configured and has lost the ability to communicate on any of the
available ports, preventing access to one of the configuration interfaces and blocking your ability to recover
the device by correcting the configuration.
Table 5 describes the sequence for OEM resetting the AirborneM2M™ devices. All devices use the same
process. However, the location of the OEM reset switch varies between product families.
Table 5 - OEM Reset Procedure
1
Disconnect or turn off the power supply.
2
Press the OEM reset (factory reset) button.
This may require the use of a small narrow object, it is important that this object is
not sharp as it may cause damage to the unit.
3
While holding the OEM button pressed reapply power to the unit.
4
Hold the OEM reset button for 5-6 seconds after power has been applied.
5
Release the OEM reset button.
6
The device will restart with the installed OEM defaults. If no OEM Configuration is
applied the device will return to B+B SmartWorx factory defaults.
See section 15.6 on use of OEM factory configurations.
To Next Page
Loading...
Need help?
General