B+B SmartWorx Airborne M2M ABDN-er-DP55 Series - Serial Port 2 Settings

AirborneM2M™ User Guide
87
SERIAL PORT 2 SETTINGS
URL /Configuration/Serial Port 2 Settings
Description Configures serial port settings on the secondary serial port.
Field CLI Command
Serial CLI Default Mode
serial-default-p2
Serial Port Bit Rate
parity-p2
Parity
parity-p2
Data Bits
data-bits-p2
Stop Bits
stop-bit-p2
Flow Control
flow-p2
Serial Assert
serial-assert-p2
Input Buffer Flush Size
input-size-p2
Serial Escape Mode
esc-mode-serial-p2
Network CLI Escape Mode
esc-mode-lan-p2
Escape String
esc-str-p2
Serial Interface Type
intf-type

Serial port 2 cannot run in RS-485 mode and will assume RS-422 mode even if it is set
to RS-485 mode. Serial port 2 cannot run half-duplex and must have a 4-wire
connection.