B+B SmartWorx Airborne M2M ABDN-er-DP55 Series - Configuring Device - Enterprise;Industrial Ethernet (Abdx-ER-Dp5 Xx;In5 Xxx); Table 15 - ER-Dp5 Xx;In5 Xxx Accessing the Web Interface

AirborneM2M™ User Guide
32
CONFIGURING DEVICE – ENTERPRISE/INDUSTRIAL ETHERNET (ABDN-ER-DP55X/-XX-IN5XXX)
The following instructions describe how access the AirborneM2M™ Ethernet device and web interface
for initial configuration of the unit.
Table 15 – ABDN-ER-DP55x / ABDN-xx-IN5xxx Accessing the Web Interface
1
Open the AirborneM2M™ packaging and locate the Install CD.
2
Place the CD in the CD/DVD drive of the laptop or desktop that you will be using to configure the
AirborneM2M™ device. Follow the onscreen directions for installation of the appropriate device
software and documentation.
3
Connect the Ethernet cable on ABDx to an Ethernet port on the laptop or desktop system.
4
Apply power to the ABDx-ER-DP5xx/IN5xxx.
5
The unit will boot and display one of the following LED patterns:
ABDx-ER-DP5xx Associated (Open Network) Not Associated
POWER:  Green  Green
LINK :  Green  Red (Periodic Blinking)
COMM:  Red  Red
ABDx-ER-IN5xxx
COMM:  Off
LINK :  Off
POST:  Orange
POWER:  Blue
6
Run the Airborne Management System application. This was installed during the CD installation and a
menu item will be found in the Airborne folder located in the programs directory of your system.
When the application opens. the following dialog will be displayed:
Select Group Name: manuf and enter Group Password: dpac