AirborneM2M™ User Guide
64
4
The status of the device will move to managed and it will be displayed under the device type/group it
belongs too. To install the VCOM driver, right-click the target device:
1. Select Configuration Management
2. Select Install VCOM Driver for OEM-Cfg1
Note: if the port selection box does not have any ports listed, cancel the install, close AMC, then restart
AMC by right-clicking the icon and clicking “Run as administrator”.
5
The VCOM driver will then be installed. When completed, the following message will be seen in the
lower right-hand corner.
The installed VCOM ports are now available for use.
7
To identify the VCOM ports, right-click My Computer.
Select Properties.
To Next Page
Loading...