To change the lament during printing, press the control wheel and do the following:
1
Select the Change lament option. The printer will stop automatically and the
following message will appear on the screen: Press & unload l.
2
Press the wheel again and then unload the lament as swiftly as possible. The
screen will then display the message Press to continue. Select this option once
you have removed the lament completely.
3
The screen will now display the message Load new lament. Load the new lament
into the printer.
Make sure the polymer is extruded from the nozzle continuously and uniformly.
4
After making sure the polymer is extruded from the nozzle continuously and
uniformly, press the control wheel to restart the printing process.
To Next Page
Loading...
