BradyPrinter i3300 6
Setup
Power
Put the Printer into Sleep Mode
When the system is asleep the display turns off and the system goes into a low power consumption
state but does not require a cold start to turn back on. In this state, you can either touch the screen or
press the power button to return the system to the same state it was in before going into lower power
consumption mode. When the printer is in sleep mode the power button is lit green.
Note: To fully shut down the printer press and hold the power button for longer than two seconds.
1. With the printer on, press and hold for approximately two seconds.
2. If there are unsaved changes in the currently active file, you will be prompted to save the
current label file.
Wake the Printer from Sleep Mode
If you do not touch the screen or keypad for a defined period of time, the system turns off the display
and goes into a low-power consumption mode. When in Sleep Mode, the power button is lit green. The
current label and settings are retained.
1. Press or touch the screen.
2. Continue with your label activities.
Reboot the Printer
Use this procedure to reboot the printer.
1. Press and hold for at least 5 seconds. The system performs the initialization process and
starts the printer.
2. When the Home page displays, you can continue with your label activities.
To Next Page
Loading...
