BradyPrinter i3300 23
Printing Labels
Printing Labels
Printing Labels
You must have labeling software installed on your computer to create, edit or print labels. Refer to your
labeling software documentation for instructions about installing and using the software. See
“Compatible Applications” on page 2 for more details.
Feeding and Cutting Label Stock
If you install label supply that has a roughly cut front edge, it is best to feed and cut the label. Also,
feed and cut if you have a partially printed job that you need to remove from within the printer.
To feed and/or cut label stock:
1. With the printer power on, press the Feed button repeatedly until the length of supply you want
exits the printer.
Note: For die-cut labels, the supply advances to the cut position which is the next die-cut label. For
continuous labels, the supply advances two inches each time you press the Feed button.
2. If desired, press Cut button. The printer will cut off the label.
To Next Page
Loading...
