BradyPrinter i3300 33
Maintenance
Cleaning the Printer
Cleaning the Cutter Blade Exit Area
This procedure cleans the cutter blade exit area and the exit chute.
Note: You should clean the exit area after cleaning the cutter blade and sensors. The cleaning
swab may be damaged when cleaning the exit area.
Materials Required
• BradyPrinter i3300 Cleaning Kit (Cat # B31-CCT)
• Isopropyl Alcohol
1. Remove power and supplies from the printer (see Pre-maintenance Operations” on page 27).
2. Close the print head door. It does not need to snap into place.
3. Using swabs from the cleaning kit moistened with alcohol, clean the exit chute entrance [12]
and exit chute ramp [13].
Note: To reach all areas of the exit chute, you can close the enclosure cover and tilt the printer up
on its side.
4. Replace the ribbon and label cartridges.
5. Close all covers, plug in the power cord, and turn on the power switch.
To Next Page
Loading...
