BradyPrinter i3300 34
Maintenance
Cleaning the Printer
Dust Cleaning
Dust generated by supply cuts can accumulate in the unit. If a significant amount of dust is built up,
clean the unit using this procedure.
Materials Required
• BradyPrinter i3300 Cleaning Kit (Cat # B31-CCT)
• Isopropyl Alcohol
• Compressed Air Bottle, purchased locally (e.g., HOSA AIR-464 Gear Duster)
1. Remove power and supplies from the printer (see Pre-maintenance Operations” on page 27).
2. Use compressed air to spray all visible areas inside the printer to remove accumulated dust.
3. Use a cloth moistened with isopropyl alcohol to wipe any remaining dust from inside the printer.
4. Wipe exterior cover and frame of printer for dirt and residue.
Cleaning the Print Head
Materials Required
• BradyPrinter i3300 Cleaning Kit (Cat # B31-CCT)
• Isopropyl Alcohol
1. Remove power and supplies from the printer (see Pre-maintenance Operations” on page 27).
2. Fill the plastic bottle from the cleaning kit with isopropyl alcohol.
Note: Do not rub the swab over the bronze-colored area of the print head.
3. Moisten one of the foam swabs from the cleaning kit with the alcohol and gently rub across the
green and black area of the print head [14].
4. Replace the ribbon and label cartridges.
5. Close all covers and plug in the power cord.
CAUTION! Always wear safety glasses when using compressed air.
CAUTION! Use only the materials supplied in the cleaning kit. Using other
materials may permanently damage the print head.
To Next Page
Loading...
