BradyPrinter i3300 8
Setup
Install or Change Supplies
4. Place ribbon cartridge with ribbon over print head (product label toward machine), then snap
into place.
5. Close and latch the print head door.
6. Close the enclosure cover.
7. If printer was asleep, press . The system detects the installed supplies, sets label and
ribbon colors, indicates the label dimensions and the amount of remaining supplies.
Install or Change Supplies
1. Open the enclosure cover.
2. Release the latch on the print head door [2] and swing open.
3. Swing yellow supply wiper [3] to the back, if engaged.
To Next Page
Loading...
