Brookfield RVDV-II+Pro - III. Options; III.1 Introduction to OPTIONS

Brookeld Engineering Labs., Inc. Page 22 Manual No. M/03-165-D0410
III. OPTIONS
III.1
OPTION
TAB
F
Introduction to OPTIONS
The OPTIONS/TAB key provides access to the conguration (Setup) of the DV-II+Pro Viscometer as
well as special functions that can enhance the user’s ability to make viscosity measurements.
The Options menu, shown in Table 1, gives a complete picture of the various conguration
choices and special functions.
Quick References to Options
Table 2
Options Menu
SETUP:
Temperature — °F or °C
Units — CGS or SI
* Speed Sets — Sequential, Interleave, Custom
Printer Port — Serial (RS232) or Parallel
Data Averaging — Display Only
*
TIME TO STOP
* TIME TO TORQUE
SET PRINT TIME:
Set the Printing Time
PC PROG (ON/OFF):
Enables/Disables Communication of Serial (RS232) Port
* DOWNLOAD A PROGRAM:
Link to PC to Receive a B.E.V.I.S. Program
(B.E.V.I.S. = Brookeld Engineering Viscometer Instruction Set)
* RUN A PROGRAM:
Execute a B.E.V.I.S. Program
*Not available when motor is ON
Pressing OPTIONS/TAB places you into the Options menu at the last option selected. The
following keys are active and perform as follows:
£
UP ARROW - Scrolls up through menu or selects new value from
list.
§
DOWN ARROW - Scrolls down through menu or selects new value
from list.