Brookfield RVDV-II+Pro - III.3 Time Modes; III.3.1 Time to Stop

Brookeld Engineering Labs., Inc. Page 29 Manual No. M/03-165-D0410
III.3 Time Modes
The Time Modes are provided to allow more exibility by unattended operating of the
viscometer during data gathering. The last selected option (i.e. Time to Torque or Time to
Stop) will be highlighted when scrolling to this option as shown in Figure III-13:
DSETUP è
DTIMETOTORQUE ê
Figure III-13
A press of the OPTIONS/TAB key will “toggle” between the two available timed modes as shown
in Figure III-14:
DSETUP è
DTIMETOTORQUE ê
DSETUP è
DTIMETOSTOP ê
"
É
Figure III-14
To enter the time for either of these options, press the ENTER/AUTORANGE key while the selected
option is blinking. Let’s start with Time To Stop.
Note: These two modes are immediately executed when input is complete. They do
not return to the default screen until running is complete. They can be stopped
at any time by a press of the MOTOR ON/OFF/ESCAPE key.
III.3.1 Time to Stop
On entry, the user is presented with the following screen display:
TIMED STOP
SET MIN’S: 00 èê
Figure III-15
Note: If a time interval has already been set, the user may skip the time interval input
and go directly to the speed input screen by pressing the ENTER/AUTORANGE
key.
Using the UP and DOWN ARROW keys, the user enters a value for the minutes portion of
the time ramp. This value can be as high as 59 minutes. When satised, the user presses the
OPTIONS/TAB key again to enter the seconds setting display: