Brookfield RVDV-II+Pro - Appendix D - Spindle and Model Codes

Brookeld Engineering Labs., Inc. Page 63 Manual No. M/03-165-D0410
Appendix D - Spindle and Model Codes
Each spindle has a two digit entry code which is entered via the keypad on the DV-II+Pro. The
entry code allows the DV-II+Pro to calculate Viscosity, Shear Rate and Shear Stress values.
Each spindle has two constants which are used in these calculations. The Spindle Multiplier
Constant (SMC) used for viscosity and shear stress calculations, and the Shear Rate Constant
(SRC), used for shear rate and shear stress calculations. Note that where SRC = 0, no shear rate/
shear stress calculations are done and the data displayed is zero (0) for these functions.
Table D1
SPINDLE ENTRY CODE SMC SRC
RV1 01 1 0
RV2
02
4 0
RV3
03 10
0
RV4
04
20 0
RV5 05
40
0
RV6
06 100
0
RV7 07
400
0
HA1 01 1 0
HA2 02 4 0
HA3 03 10 0
HA4 04 20 0
HA5 05 40 0
HA6 06 100 0
HA7 07 400 0
HB1 01 1 0
HB2 02 4 0
HB3 03 10 0
HB4 04 20 0
HB5 05 40 0
HB6 06 100 0
HB7 07 400 0
LV1 61 6.4 0
LV2 62 32 0
LV3 63 128 0
LV4 or 4B2 64 640 0
LV5 65 1280 0
LV-2C 66 32 0.212
LV-3C 67 128 0.210
Spiral 70 105 0.677
T-A 91 20 0
T-B 92 40 0
T-C 93 100 0