Brookfield RVDV-II+Pro - III.2.2 Units of Measurement; III.2.3 Motor Speed Set Selection

Brookeld Engineering Labs., Inc. Page 26 Manual No. M/03-165-D0410
A press of the OPTIONS/TAB key at this point will “toggle” between the two available
temperature scale options as shown in Figure III-5:
D°F(FAHRENHEIT) è
DCGS UNITS ê
D°C(CENTIGRADE) è
DCGS UNITS ê
"
Figure III-5
To select the temperature display mode, press the ENTER/AUTORANGE key. You automatically
exit the Setup menu with the viscometer displaying temperature in the selected scale. You
must press the ENTER/AUTORANGE key to select the ashing option.
III.2.2 Units of Measurement
Selecting units of measurement is identical to that for temperature described above. The screen
display shows:
D°F(FAHRENHEIT) è
DCGSUNITS ê
Figure III-6
A press of the OPTIONS/TAB key at this point allows the user to “toggle” between the two
available data display units as shown in Figure III-7:
D°F(FAHRENHEIT) è
DCGSUNITS ê
DF(FAHRENHEIT) è
DSIUNITS ê
"
É
Figure III-7
Pressing the ENTER/AUTORANGE key selects the display units, which are ashing, followed by an
exit of the Setup menu. You must press the ENTER/AUTORANGE key to select the ashing option.
III.2.3 Motor Speed Set Selection
This selection must be done with the motor off. Scrolling in the Setup options menu to the
speed set selection option yields the following screen display:
DCGS UNITS è
DSEQUENTIAL ê
Figure III-8